Woods digital timer

Woods® Dual Outlet Digital Timer Instructions for Super Feeder Operation

Before programming the timer, adjust the feeder's internal feed timer as directed in its operating manual by plugging the power adapter cord into the feeder and the power adapter directly into a power outlet. Use the small plastic screwdriver supplied to turn the little white dial located under the lateral rubber plug to control the feed cycle time for desired portion size.

  1. First, charge timer's internal battery for at least 1 hour before use.
  2. Push the small recessed "reset" switch with a paperclip or similar item until you see all 88:88
  3. Press and hold the "clock" button down, push the "day" button repeatedly until you point the cursor at the top of the window to the current day of week.
  4. While holding "clock" button down, push the "hour" button repeatedly until you have the correct hour and AM or PM in the window.
  5. While holding "clock" button down, push the "minute" button repeatedly until you have the correct minute(s) in the window.
  6. Release the "clock" button.

To program feed cycles at the same time(s) all 7 days of the week:

  1. Push the "program" button once and you should see a "1" (first feed cycle) AM or PM and "ON" in the window
  2. Push the "day" button once and you should have all 7 cursors at the top of the window under all 7 days of the week and have "AM" and "ON" in the window.
  3. Push "hour" button repeatedly until you have the desired hour and AM or PM in the window you want your first feed cycle to occur. You will be programming the "OFF" time the same way.
  4. Push "minute" button repeatedly until you have the minute(s) set for the time you want the feeder to turn on. You will be programming the "OFF" time the same way.
  5. Push the "program" button one more time and you should see a "1" (first feed cycle) AM or PM and "OFF" to program your off time.
  6. Repeat steps 3 and 4 to program "OFF" time 2 minutes later than "ON" time you previously selected. Example: 5:00 AM "ON" and 5:02 AM "OFF" This will be your first feeding time.
  7. Repeat above sequence for additional feed cycles up to 8 times per day making sure that you have at least 2 minutes of "off" time between subsequent programmed feed times. Example: You may feed twice in as little time span as 5 minutes. We recommend feeding small portions several times per day.
  8. When done, push the clock button and then cycle the "manual" button until you have the cursor at the bottom of the window facing "AUTO" and "OFF" (NOT flashing "ON!!") for automatic mode.
  9. Note: You may turn on your feeder manually by pushing the "manual" button until you have the cursor at the bottom of the window facing "manual" and flashing "on" in the window, but make sure you return it to "auto" and "off" for automatic operation.

Note: For additional information, review the manufacturer's operating manual.

Back to Main Installation page